
Project introduction
This pattern overview looks at a bucket bag that pairs a classic rounded shape with a bright marigold motif, giving a finished accessory a handmade, boho-inspired character. It is a starting point if you want to understand the shape, the supplies, and the way the pieces come together before you open the full instructions. For the complete stitch-by-stitch directions, follow the Original designer’s pattern and instructions.
Marigolds are noted as October’s birth flower and as symbols of sunny beauty, so the floral embroidery suits an autumn gift or an everyday bag. The project is rated Intermediate, and the finished bag measures 9 inches (23 cm) across and 13 inches (33 cm) tall. The stated gauge is 19 stitches and 20 rows in single crochet for every 4 inches (10 cm).
Materials

Gather everything before you start, because the color changes, the optional stiffening layer, and the finishing details are easier to manage with the notions close at hand. The list below follows the source, so check each yarn color and ball count against your stash before you begin.
- Lily Sugar ‘n Cream, 100% cotton, 120 yards (109 meters) per 70.9 grams: Black, main color, 7 balls.
- Same yarn line: Wine, CC1, 1 ball; Country Red, CC2, 1 ball; Dark Pine, CC3, 1 ball.
- Peaches & Crème, 100% cotton, 120 yards (109 meters) per 70.9 grams: Gold, CC4, 1 ball.
- Hook: US size E/4 (3.5 mm).
- Notions: removable stitch marker, pins, tapestry needle, optional 8 inch diameter plastic canvas circle.
Special Stitches
Only one special stitch needs attention before the fabric begins, and learning its direction will save time at the top edge. Reverse single crochet is worked into the stitch to the right rather than the stitch to the left, using a yarn over and pull-through sequence that ends by pulling through both loops on the hook.
Pattern Notes
The bag is built from two parts: a double-layered round bottom and a rectangular side panel measuring 13 inches (33 cm) by 32 inches (81 cm). The bottom pieces are worked in a continuous spiral without joining between rounds, and the optional canvas layer can be sandwiched inside for strength. The side panel is worked in rows with a buttonhole row near the top for a drawstring cord, then embroidered, seamed into a cylinder, and joined to the bottom, with a border round around the top.
Round Bottom (make 2)
Two matching round pieces form the base, and both are worked in the main color in rounds of single crochet. The shape grows from a small center outward, so the circles stay flat enough to support the sides. Once both pieces are complete, they are prepared as a pair for assembly, with the optional stiffening layer placed between them if you choose that finish.
Rectangle
The side panel is a long rectangular piece worked in the main color in single crochet rows, giving the bag an even fabric that lets the embroidery stand out. Most rows follow the same rhythm, which makes this section a good place to settle into a pace. A buttonhole row near the top creates the openings for the drawstring, and a few final rows complete the panel before it is fastened off.
Strap
The strap is a long, narrow piece worked in slip stitch rows, with the main color framing a sequence of contrast-color rows in the middle. Working in the back loop gives the strap a flexible texture that pairs well with the body fabric, while the color sequence echoes the marigold palette without competing with the motif.
Finishing
Finishing begins with the bottom, where the two round pieces are joined around the edge in the main color, enclosing the optional canvas layer when it is used and keeping the right sides facing outward. The motif is embroidered outward from a marked center stitch, with cross stitches placed over the single crochet fabric in the contrast colors shown on the marigold chart. Working from the center outward helps the flower stay balanced.
Border
Once the panel is embroidered, its short ends are seamed together to form a cylinder, and a reverse single crochet border round is added around the top edge. The cylinder is then pinned and joined to the round bottom, while the strap is sewn inside at a suitable height, taking care not to cover a buttonhole. The drawstring is a braided cord finished to 30 inches (76 cm), threaded through the buttonholes, with a tassel at each end trimmed to 4 inches (10 cm).
Pattern Charts, Diagrams or Schematics are Available for Download for Gold Members.
Charts, diagrams, or schematics for this project are available for download to Gold Members through the original source, so makers who prefer a guide can check that option before they begin. Existing Gold Members are prompted to log in, while new visitors are prompted to sign up, and the written pattern link in the introduction remains the place to start for the instructions.



